• Molded polyurethane. The foam will be non sagging (Density : 50 +/-5 kg /M3 )
• CRC sheet in push back system and side stand of the as shown in (photograph).
• 12 mm Ply seat and M.S. Flat 25 mm x 5 mm and flat of size 25 mm x 3 mm in frame of back.
• M.S. Pipe of size 25 mm x 25 mm 18G from arms and of size 25 mm x 25 mm for arm holder.
• Push back system
   • Synchronized push back system, 16G seat supporting tray (as per model).
   • 2 Nos 14 G back clamps.
   • 2 Nos 16 G roller holders with 2 Nos 30 mm rollers.
   • 1 Nos 50 x 25 mm MS tubes of 16 G tubes.
   • 2 Nos of 25 x 6 mm MS flat arms.
• Side stand
• Heavy gauge as per design and construction.
• 16 gauge one piece footrest.
• Side panel Covered with duly laminated upholstery fabric, in seat and back.
• Arms rests (with cup holder) will of PPCP molded in shape and design.
• The distance between center to center of arms of the chair will be 21” to 23” as per requirement.
• The total height of the chair from floor level will be 40”.
• Seat and back will be covered with 100% polyester fabric.